Please type in at least 2 characters
Please type in at least 2 characters
Browse Categories
Bags & Travel Accessories
Electronics & Mobiles
Computer & Peripherals
Smart TV & Accessories
School Supplies
Toys & Kids Learning
Office Supplies
Arts & Crafts
Arabic Books
English Books
Audio & eBooks
Gaming
Digital Cards
Musical Instruments
Item 1 of 1
Item 1 of 1
LAP Lambert Academic Publishing
Sustainable Machining
SR 272
Inclusive of VAT
SR16Per Month/24 months
This book is printed on demand and is non-refundable after purchase
Available Formats :
Printed Book
It will be sent to your address
SR272
Incl. VAT
Secure Shopping
Convenient Returns
Genuine & Warranted
Fast Delivery
Or
About this Product
The turning operation was performed using two levels of cutting speed while the feed rate and depth of cut were kept fixed. The SEM images were analyzed for worn toolsurfaces and machined surfaces. The microhardness analysis indicated heat-based attention in the turned workpiece; thus, the heat-based effect was lowest in MQL compared to RHVT, compressed air, and dry conditions. Results demonstrated MQL can significantly lower tool tip temperature by up to 16 %, tool wear by up to 102%-106%, average cutting forces by 17% -21%, surface roughness reduced by experiments in Stage II were performed on Al7075-T6 alloy by selecting Taguchisorthogonal array technique with three control factors and four levels for every factor, the experimental design matrix was created via Minitab 17 statistical tool11% -21% and energy consumption by 4.4 -3.7% as compared to dry conditions.A depth of 1 mm was fixed for all the experiments conducted. To lower the noise errors and develop more precise output results, every group of the experimental run was done three times, for a total of 48 trials (16 ×3 runs).
Report an issue with this product.
